Overview

Osmo UV-Protection Oil Tints is a satin, natural oil-based finish ideal for use on all vertical wood surfaces in outdoor areas. Recommended for use on doors, windows, shutters, cladding, fences, pergolas, and summer houses. As a topcoat on already colour treated wood, Osmo UV-Protection-Oil Tints prolongs the renovation intervals significantly. As a single product application, it blocks the greying process on vertical surfaces with a UV protection factor of 12 in comparison to untreated wood when two coats are applied.

• Very water and dirt resistant
• Does not crack, peel, or flake
• Resists growth of algae, mildew, and fungi
• Low odour

Preparation

Ensure the surface is clear from debris, dry and frost-free

• Clean old microporous stains thoroughly.
• Old paints and lacquers must be completely removed by sanding or using a paint stripper such as . Do not sand smooth surfaces finer than grit P120.
• If you have weathered or greying wood it may affect the finished colour we would advise using prior to application.
• If additional protection against blue stain, rot and insects is desired, pre-treat the wood if possible on all sides with Osmo WR Base Coat.

Note: Fresh, especially hardwood rich in extractives needs to weather off for approximately 6 weeks after installation. Thereby the wood becomes absorbent and the oil finish adheres optimally.

Application

Before applying the product test a small area on the surface to be treated to ensure you are happy with the finished results. Results are influenced by the condition of the wood therefore a trial application is highly recommended.

• Stir the product thoroughly.
• Apply using a brush we recommend using .
• Apply thinly evenly along the wood grain and spread well.
• Allow to dry for 12 hours under good ventilation.
• Apply a second coat as above.

Note: Always follow the manufacturer's instructions found on the bottle.

Aftercare & Storage

Cleaning

Damp cleaning with . Using general or multi-purpose cleaners will increase the frequency of maintenance and recoating.

Maintenance

If necessary, intensive cleaning and refreshing using or .

Recoating

Simply re-apply one coat onto the clean and dry surface when signs of wear become visible.